Part No. 122985 S-80 • S-85 • S-80X 3 - 11Section 3 • Scheduled Maintenance ProceduresFebruary 2012CHECKLIST A PROCEDURESA-8Perform Engine Maintenance -Deutz and Continental ModelsEngine specifications require that this one-timeprocedure be performed after the first 50 hours ofoperation.Proper engine maintenance, following the enginemanufacturer's maintenance schedule, is essentialto good engine performance and service life. Failureto perform the maintenance procedures can lead topoor engine performance and component damage.Required maintenance procedures forcommissioning new and overhauled engines andadditional engine information are available in theDeutz TD2011 Operation Manual(Deutz part number 0312 3547)OR theContinental TME27 Owner's Manual(Continental part number WM10303).Deutz TD2011 Operation ManualGenie part number 139320Continental TME27 Owner's ManualGenie part number 111901To access the engine:1 Remove the engine tray retaining fastenerlocated under the engine tray. Swing the enginetray out away from the machine and secure itfrom moving.Crushing hazard. Failure to installthe fastener into the engine trayanchor hole to secure the enginetray from moving could result indeath or serious injury.A-9Inspect the Fuel Filter/WaterSeparator - Diesel ModelsNote: Genie specifications require that thisprocedure be performed every 100 hours ormonthly, whichever comes first.Proper maintenance of the fuel filter/water separatoris essential for good engine performance. Failure toperform this procedure can lead to poor engineperformance and/or hard starting, and continueduse may result in component damge. Extremelydirty conditions may require this procedure beperformed more often.Explosion and fire hazard. Enginefuels are combustible. Perform thisprocedure in an open, well-ventilated area away from heaters,sparks, flames and lightedtobacco. Always have an approvedfire extinguisher within easy reach.Note: Perform this procedure with the engine off.Perkins Models:1 Put on protective clothing and eye wear.2 Open the engine side turntable cover and locatethe fuel filter/water separator next to thehydraulic return filter on the bulkhead.3 Inspect the filter bowl for water buildup.Result: If water is present in the filter bowlcontinue with steps 4 through 8.
