Part No. 122985 S-80 • S-85 • S-80X 3 - 19Section 3 • Scheduled Maintenance ProceduresFebruary 2012CHECKLIST B PROCEDURES10 Check the ambient air temperature and adjustthe specific gravity reading for each cell asfollows:• Add 0.004 to the reading of each cell forevery 10° / 5.5° C above 80° F / 26.7° C.• Subtract 0.004 from the reading of each cell forevery 10° / 5.5° C below 80° F / 26.7° C.Result: All battery cells display a specific gravityof 1.277 or greater. The battery is fully charged.Proceed to step 11.Result: The difference in specific gravityreadings between cells is greater than 0.1 ORthe specific gravity of one or more cells is lessthan 1.177. Replace the battery.11 Check the battery acid level. If needed,replenish with distilled water to 1/8 inch / 3 mmbelow the bottom of the battery fill tube. Do notoverfill.12 Install the vent caps and neutralize anyelectrolyte that may have spilled.a bB-2Inspect the Electrical WiringGenie specifications require that this procedure beperformed every 250 hours or quarterly, whichevercomes first.Maintaining electrical wiring in good condition isessential to safe operation and good machineperformance. Failure to find and replace burnt,chafed, corroded or pinched wires could result inunsafe operating conditions and may causecomponent damage.Electrocution/ burn hazard.Contact with hot or live circuitscould result in death or seriousinjury. Remove all rings, watchesand other jewelry.1 Open the turntable cover at the engine side ofthe machine.2 Remove the engine tray retaining fastener.Swing the engine tray out away from themachine.a engine tray anchor holeb engine tray retaining fastener
