Part No. 75861 Genie Z-60/34 3 - 13November 2003 Section 3 • Scheduled Maintenance ProceduresREV A CHECKLIST A PROCEDURES9 Install the new regulator/filter. Connect the fuelhoses to the regulator/filter.Component damage hazard. Besure the correct regulator/filter isinstalled or component damagemay occur.Be sure each fuel hose isconnected to the correct port of thepressure/regulator.10 Install the fuel hose from the fuel tank to the fuelpre-filter.11 Clean up any fuel that may have spilled duringthe installation procedure.12 Start the machine from the ground controls.Inspect the fuel filters and hoses for leaks.Explosion and fire hazard. If a fuelleak is discovered, keep anyadditional personnel from enteringthe area and do not operate themachine. Repair the leakimmediately.A-12Inspect the Fuel Filter/ WaterSeparator - Deutz ModelsEngine specifications require thatthis procedure be performed every100 hours.Proper maintenance of the fuel filter/water separatoris essential for good engine performance. Failure toperform this procedure can lead to poor engineperformance and component damage.Explosion and fire hazard. Enginefuels are combustible. Perform thisprocedure in an open, well-ventilated area away from heaters,sparks, flames and lightedtobacco. Always have an approvedfire extinguisher within easy reach.Perform this procedure with theengine off.1 Put on protective clothing and eye wear.2 Remove the two engine pivot plate retainingbolts. Swing the engine pivot plate out awayfrom the machine and secure it from moving.Crushing hazard. Failure to securethe engine pivot plate from movingcould result in death or seriousinjury.
