Part No. 75861 Genie Z-60/34 3 - 39November 2003 Section 3 • Scheduled Maintenance ProceduresREV AC-4Perform Engine Maintenance -Ford ModelsFord engine specifications requirethat this procedure be performedevery 800 hours.Proper engine maintenance, following the enginemanufacturer's maintenance schedule, is essentialto good engine performance and service life. Failureto perform the maintenance procedures can lead topoor engine performance and component damage.Required maintenance procedures and additionalengine information are available in theFord LRG-425 EFI Operator Handbook(Ford part number FPP 194-302).Ford LRG-425 EFI Operator HandbookGenie part number 77831To access the engine:1 Remove the two engine pivot plate retainingbolts. Swing the engine pivot plate out awayfrom the machine and secure it from moving.Crushing hazard. Failure to securethe engine pivot plate from movingcould result in death or seriousinjury.10 Test all machine functions from the groundcontrols.Result: All ground control functions should notoperate.Machine functions should stilloperate with auxiliary power at theground controls.11 Lift the test weights off the platform floor using asuitable lifting device.Result: The platform overload indicator light andalarm should turn off at both the ground andplatform controls.There may be an approximate 2second delay before the overloadindicator light and alarm turn off.12 Test all machine functions from the groundcontrols.Result: All ground control functions shouldoperate normally.13 Turn the key switch to platform control.14 Test all machine functions from the platformcontrols.Result: All platform control functions shouldoperate.If the platform overload system isnot operating properly, see D-6,How to Calibrate the PlatformOverload System.CHECKLIST C PROCEDURES
