3 - 34 Genie Z-60/34 Part No. 75861November 2003Section 3 • Scheduled Maintenance ProceduresREV ACHECKLIST B PROCEDURES11 Inspect the housing seals and replace them ifnecessary.12 Install the new filter elements into the housingsand tighten them securely.The medium and high pressurefilters use the same elements.13 Clean up any oil that may have spilled during theinstallation procedure.14 Use a permanent ink marker to write the dateand number of hours from the hour meter on theoil filter housings.15 Start the engine from the ground controls.16 Inspect the filter housings and relatedcomponents to be sure that there are no leaks.B-22Perform Engine Maintenance -Deutz ModelsDeutz engine specifications requirethat this procedure be performedevery 400 hours.Proper engine maintenance, following the enginemanufacturer's maintenance schedule, is essentialto good engine performance and service life. Failureto perform the maintenance procedures can lead topoor engine performance and component damage.Required maintenance procedures and additionalengine information are available in theDeutz FL 1011F Operation Manual(Deutz part number 0297 9683).Deutz FL 1011F Operation ManualGenie part number 52883To access the engine:1 Remove the two engine pivot plate retainingbolts. Swing the engine pivot plate out awayfrom the machine and secure it from moving.Crushing hazard. Failure to securethe engine pivot plate from movingcould result in death or seriousinjury.
