286DDR commandsCommands and descriptions for centralized devices apply to the following routers:• MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE/810-LM-HK/810-W-LM-HK/810-LMS/810-LUS.• MSR2600-10-X1.• MSR 2630.• MSR3600-28/3600-51.• MSR3600-28-SI/3600-51-SI.• MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-DP-DC.MSR 3610/3620/3620-DP/3640/3660.Commands and descriptions for distributed devices apply to the following routers:• MSR5620.• MSR 5660.• MSR 5680.IPv6-related parameters are not supported on the following routers:• MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE/810-LM-HK/810-W-LM-HK/810-LMS/810-LUS.• MSR3600-28-SI/3600-51-SI.MSR3600-28-SI and MSR3600-51-SI routers do not support DDR commands.bandwidthUse bandwidth to set the expected bandwidth for a dialer interface.Use undo bandwidth to restore the default.Syntaxbandwidth bandwidth-valueundo bandwidthDefaultThe expected bandwidth (in kbps) is the interface baud rate divided by 1000.ViewsDialer interface viewPredefined user rolesnetwork-adminParametersbandwidth-value: Specifies the expected bandwidth in the range of 1 to 400000000 kbps.Usage guidelinesThe expected bandwidth of an interface affects the link costs in OSPF, OSPFv3, and IS- IS. For moreinformation, see Layer 3—IP Routing Configuration Guide.Examples# Set the expected bandwidth of Dialer 1 to 100 kbps.
