1-5z In the Layer 2 aggregate interfaces view, you can’t configure the MAC Learning Limit.z When a port is the member of the aggregation group, in Ethernet port view, you can’t configure theMAC Learning LimitDisplaying and Maintaining MAC Address TableTo do… Use the command… Remarksdisplay mac-addressblackhole [ vlan vlan-id ][ count ]Display MAC address tableinformationdisplay mac-address[ mac-address [ vlan vlan-id ] |[ dynamic | static ] [ interfaceinterface-typeinterface-number ] [ vlanvlan-id ] [ count ] ]Display the aging timer fordynamic MAC address entriesdisplay mac-addressaging-timeDisplay MAC address statistics display mac-addressstatisticsAvailable in any viewMAC Address Table Configuration ExampleNetwork requirementsLog onto your device from the Console port to configure MAC address table management as follows:z Set the aging timer to 500 seconds for dynamic MAC address entries.z Add a static entry 000f-e235-dc71 for port GigabitEthernet 1/0/1 in VLAN 1.Configuration procedure# Add a static MAC address entry. system-view[Sysname] mac-address static 000f-e235-dc71 interface gigabitethernet 1/0/1 vlan 1# Set the aging timer for dynamic MAC address entries to 500 seconds.[Sysname] mac-address timer aging 500# Display the MAC address entry for port GigabitEthernet 1/0/1.[Sysname] display mac-address interface gigabitethernet 1/0/1MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)000f-e235-dc71 1 Config static GigabitEthernet 1/0/1 NOAGED--- 1 mac address(es) found ---
