1-38NQA Collaboration Configuration ExampleNetwork requirementsAs shown in Figure 1-13, configure a static route to Switch C on Switch A, with Switch B as the next hop.Associate the static route, track entry, and NQA test group to verify whether static route is active in realtime.Figure 1-13 Network diagram for NQA collaboration configuration exampleVlan-int210.1.1.1/24Vlan-int210.1.1.2/24Vlan-int310.2.1.1/24Switch CVlan-int310.2.1.2/24Switch BSwitch AConfiguration procedure1) Assign each interface an IP address. (omitted)2) On Switch A, configure a unicast static route and associate the static route with a track entry.# Configure a static route, whose destination address is 10.2.1.1, and associate the static route withtrack entry 1. system-view[SwitchA] ip route-static 10.1.1.2 24 10.2.1.1 track 13) On Switch A, create an NQA test group.# Create an NQA test group with the administrator name being admin and operation tag being test.[SwitchA] nqa entry admin test# Configure the test type of the NQA test group as ICMP echo.[SwitchA-nqa-admin-test] type icmp-echo# Configure the destination IP address of the ICMP echo test operation as 10.2.1.1.[SwitchA-nqa-admin-test-icmp-echo] destination ip 10.2.1.1# Configure the interval between two consecutive tests as 100 milliseconds.[SwitchA-nqa-admin-test-icmp-echo] frequency 100# Create collaboration entry 1. If the number of consecutive probe failures reaches 5, collaboration withother modules is triggered.[SwitchA-nqa-admin-test-icmp-echo] reaction 1 checked-element probe-fail threshold-typeconsecutive 5 action-type trigger-only[SwitchA-nqa-admin-test-icmp-echo] quit# Configure the test start time and test duration for the test group.[SwitchA] nqa schedule admin test start-time now lifetime forever4) On Switch A, create the Track entry.# Create Track entry 1 to associate it with Reaction entry 1 of the NQA test group (admin-test).
