1-6z If the timestamp starts with a %, the information is log informationz If the timestamp starts with a #, the information is trap informationz If the timestamp starts with a *, the information is debugging informationsourceThis field indicates the source of the information, such as the source IP address of the log sender. Thisfield is optional and is displayed only when the output destination is the log host.contentThis field provides the content of the system information.Configuring Information CenterInformation Center Configuration Task ListComplete the following tasks to configure information center:Task RemarksOutputting System Information to the Console OptionalOutputting System Information to a Monitor Terminal OptionalOutputting System Information to a Log Host OptionalOutputting System Information to the Trap Buffer OptionalOutputting System Information to the Log Buffer OptionalOutputting System Information to the SNMP Module OptionalConfiguring Synchronous Information Output OptionalOutputting System Information to the ConsoleOutputting system information to the consoleTo do… Use the command… RemarksEnter system view system-view —Enable information center info-center enable OptionalEnabled by defaultName the channel with aspecified channel numberinfo-center channelchannel-number namechannel-nameOptionalRefer to Table 1-2 for defaultchannel names.Configure the channel throughwhich system information canbe output to the consoleinfo-center console channel{ channel-number |channel-name }OptionalBy default, system informationis output to the console throughchannel 0 (known as console).
