1-37DLSw Test Configuration ExampleNetwork requirementsUse the NQA DLSw function to test the response time of the DLSw device.Figure 1-12 Network diagram for the DLSw testsConfiguration procedure# Create a DLSw test group and configure related test parameters. system-view[DeviceA] nqa entry admin test[DeviceA-nqa-admin-test] type dlsw[DeviceA-nqa-admin-test-dlsw] destination ip 10.2.2.2[DeviceA-nqa-admin-test-dlsw] quit# Enable DLSw test.[DeviceA] nqa schedule admin test start-time now lifetime forever# Disable DLSw test after the test begins for a period of time.[DeviceA] undo nqa schedule admin test# Display the result of the last DLSw test.[DeviceA] display nqa result admin testNQA entry(admin admin, tag test) test results:Destination IP address: 10.2.2.2Send operation times: 1 Receive response times: 1Min/Max/Average round trip time: 19/19/19Square-Sum of round trip time: 361Last succeeded probe time: 2007-11-22 10:40:27.7Extended results:Packet lost in test: 0%Failures due to timeout: 0Failures due to disconnect: 0Failures due to no connection: 0Failures due to sequence error: 0Failures due to internal error: 0Failures due to other errors: 0Packet(s) arrived late: 0# Display the history of DLSw tests.[DeviceA] display nqa history admin testNQA entry(admin admin, tag test) history record(s):Index Response Status Time1 19 Succeeded 2007-11-22 10:40:27.7
