1-3Configuring Monitor Link Group Member PortsYou can configure member ports for a monitor link group either in monitor link group view or interfaceview. The configurations made in these two views lead to the same result.In monitor link group viewFollow these steps to configure member ports for a monitor link group in monitor link group view:To do… Use the command… RemarksEnter system view system-view —Enter monitor link group view monitor-link group group-id —Configure member ports for the monitorlink groupport interface-typeinterface-number { uplink |downlink }RequiredIn interface viewFollow these steps to configure member ports for a monitor link group in interface view:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet interface view or Layer 2aggregate interface viewinterface interface-typeinterface-number —Configure the current interface as amember of a monitor link groupport monitor-link groupgroup-id { uplink | downlink } Requiredz You can assign a Layer 2 Ethernet interface or Layer 2 aggregate interface to a monitor link groupas a member port.z A port can be assigned to only one monitor link group.z You are recommended to configure uplink ports prior to downlink ports, thus avoiding undesireddown/up state changes on the downlink ports.Displaying and Maintaining Monitor LinkTo do… Use the command… RemarksDisplay monitor link groupinformationdisplay monitor-link group{ group-id | all } Available in any view
