1-10To guarantee a successful dynamic aggregation, ensure that the peer ports of the ports aggregated atone end are also aggregated. The two ends can automatically negotiate the aggregation state of eachmember port.Follow these steps to configure a dynamic aggregation group:To do... Use the command... RemarksEnter system view system-view —Set the system LACP priority lacp system-prioritysystem-priorityOptionalBy default, the system LACPpriority is 32768.Changing the system LACPpriority may affect theaggregation state of the ports ina dynamic aggregation group.Create a Layer 2 aggregateinterface and enter the Layer 2aggregate interface viewinterface bridge-aggregationinterface-numberRequiredWhen you create a Layer 2aggregate interface, the systemautomatically creates a Layer 2static aggregation groupnumbered the same.Configure the aggregationgroup to work in dynamicaggregation modelink-aggregation modedynamicRequiredBy default, an aggregationgroup works in staticaggregation mode.Exit to system view quit —Enter Layer 2 Ethernetinterface viewinterface interface-typeinterface-numberAssign the Ethernet interface tothe aggregation groupport link-aggregation groupnumberRequiredRepeat these two steps toassign multiple Layer 2Ethernet interfaces to theaggregation group.Assign the port a LACP priority lacp port-priority port-priorityOptionalBy default, the LACP priority ofa port is 32768.Changing the LACP priority of aport may affect the aggregationstate of the ports in the dynamicaggregation group.Configuring an Aggregate InterfaceYou can perform the following configurations on an aggregate interface:z Configuring the Description of an Aggregate Interfacez Enabling Link State Trapping for an Aggregate Interfacez Shutting Down an Aggregate Interface
