1-3z Use the save command to save the current configuration before you reboot the device to avoidconfiguration lost. (For details of the save command, refer to File System ManagementConfiguration in the System Volume.)z Use the display startup command and the display boot-loader command to verify theconfiguration files and the startup file to be used at the next system startup before you reboot thedevice. (For details of the display startup command, refer to File System ManagementConfiguration in the System Volume.)z The precision of the rebooting timer is 1 minute. One minute before the rebooting time, the devicewill prompt “REBOOT IN ONE MINUTE” and will reboot in one minute.z When you execute the reboot command on the master, if you specify the slot keyword, themember device with the specified number will reboot; if you do not specify the slot keyword, allmember devices in the IRF will reboot.z Device reboot may result in the interruption of the ongoing services. Use these commands withcaution.z If a main boot file fails or does not exist, the device cannot be rebooted with the reboot command.In this case, you can re-specify a main boot file to reboot the device, or you can power off thedevice then power it on and the system automatically uses the backup boot file to restart thedevice.z If you are performing file operations when the device is to be rebooted, the system does notexecute the command for the sake of security.Configuring the Scheduled Automatic Execution FunctionThe scheduled automatic execution function means that the system automatically executes a specifiedcommand at a specified time in a specified view. This function is used for scheduled system upgrade orconfiguration.Follow these steps to configure the scheduled automatic execution function:To do… Use the command… RemarksAutomatically execute thespecified command at thespecified timeschedule job at time [ date ]view view commandAutomatically execute thespecified command after thespecified delayschedule job delay time viewview commandOptionalIf you configure the function,use either commandAvailable in user viewNote that:z At present, you can specify user view and system view only. To automatically execute the specifiedcommand in another view or automatically execute multiple commands at a time, you canconfigure the system to automatically execute a batch file at the specified time (note that you mustprovide a complete file path for the system to execute the batch file.).z The system does not check the values of the view and command arguments. Therefore, ensure thecorrectness of the command argument (including the correct format of command and the correctrelationship between the command and view arguments).
