1-18Configuration prerequisitesEnable the DLSw function on the peer device before DLSw test.Configuring a DLSw testFollow these steps to configure a DLSw test:To do… Use the command… RemarksEnter system view system-view —Enter NQA test group view nqa entry admin-nameoperation-tag —Configure the test type asDLSw and enter test type view type dlsw RequiredConfigure the destinationaddress for a test operation destination ip ip-addressRequiredBy default, no destination IPaddress is configured for a testoperation.Configure the source IPaddress of a probe request in atest operationsource ip ip-addressOptionalBy default, no source IPaddress is specified.The source IP address must bethat of an interface on thedevice and the interface mustbe up. Otherwise, the test willfail.Configure common optionalparametersSee Configuring OptionalParameters Common to anNQA Test GroupOptionalConfiguring the Collaboration FunctionCollaboration is implemented by establishing collaboration objects to monitor the detection results ofthe current test group. If the number of consecutive probe failures reaches the threshold, the configuredaction is triggered.Follow these steps to configure the collaboration function:To do… Use the command… RemarksEnter system view system-view —Enter NQA test group view nqa entry admin-name operation-tag —Enter test type view of thetest grouptype { dhcp | dlsw | ftp | http |icmp-echo | snmp | tcp | udp-echo }The collaboration functionis not supported in UDPjitter or voice tests.Create a collaborationobjectreaction item-num checked-elementprobe-fail threshold-typeconsecutive occurrences [ action-type{ none | trigger-only } ]RequiredNot created by default.Exit to system view quit —
