1-7LLDP-related configurations made in Ethernet interface view takes effect only on the current port, andthose made in port group view takes effect on all ports in the current port group.Performing Basic LLDP ConfigurationEnabling LLDPTo make LLDP take effect on certain ports, you need to enable LLDP both globally and on these ports.Follow these steps to enable LLDP:To do… Use the command… RemarksEnter system view system-view —Enable LLDP globally lldp enableRequiredBy default, LLDP is enabledglobal.Enter Ethernetinterface viewinterface interface-typeinterface-numberEnterEthernetinterfaceview or portgroup viewEnter portgroup viewport-group manualport-group-nameRequiredUse either command.Enable LLDP lldp enableOptionalBy default, LLDP is enabled ona port.Setting LLDP Operating ModeLLDP can operate in one of the following modes.z TxRx mode. A port in this mode sends and receives LLDP frames.z Tx mode. A port in this mode only sends LLDP frames.z Rx mode. A port in this mode only receives LLDP frames.z Disable mode. A port in this mode does not send or receive LLDP frames.Follow these steps to set LLDP operating mode:To do… Use the command… RemarksEnter system view system-view —Enter Ethernetinterface viewinterface interface-typeinterface-numberEnterEthernetinterfaceview or portgroup viewEnter portgroup viewport-group manualport-group-nameRequiredUse either command.Set the LLDP operating mode lldp admin-status { disable |rx | tx | txrx }OptionalTxRx by default.
