1-6To do… Use the command… RemarksEnter Ethernet orLayer 2aggregateinterface viewinterface interface-typeinterface-numberEnterEthernetinterfaceview, Layer2 aggregateinterfaceview, orport-groupviewEnter port-groupviewport-group manualport-group-nameRequiredPerform either of thecommands.Depending on the view youaccessed, the subsequentconfiguration takes effect on aport or all ports in aport-group.Configure the Hold timer garp timer hold timer-value Optional10 centiseconds by default.Configure the Join timer garp timer join timer-value Optional20 centiseconds by default.Configure the Leave timer garp timer leave timer-value Optional60 centiseconds by default.As shown in Table 1-2, the values of GARP timers are dependent on each other:z If you want to set a value beyond the value range for a timer, you may change the value range bytuning the value of another related timer.z If you want to restore the default settings of the timers, restore the Hold timer first, and then the Join,Leave, and LeaveAll timers.Table 1-2 Dependencies of GARP timersTimer Lower limit Upper limitHold 10 centiseconds No greater than half of the Join timersettingJoin No less than two times the Hold timersetting Less than half of the leave timer settingLeave Greater than two times the Join timersetting Less than the LeaveAll timer settingLeaveAll Greater than the Leave timer setting 32765 centisecondsDisplaying and Maintaining GVRPTo do… Use the command… RemarksDisplay statistics about GARP display garp statistics [ interfaceinterface-list ] Available in any viewDisplay GARP timers for specifiedor all portsdisplay garp timer [ interfaceinterface-list ] Available in any viewDisplay the local VLAN informationmaintained by GVRPdisplay gvrp local-vlan interfaceinterface-type interface-number Available in any view
