1-8z Because any port attribute or class-two configuration change on a member port may cause theaggregation state of the port and other member ports to change and thus affect services, you arerecommended to do that with caution.z In a dynamic aggregation group, when the aggregation state of a local port changes, theaggregation state of the peer port also changes accordingly.Load Sharing Criteria for Link Aggregation GroupsIn a link aggregation group, traffic may be load-shared across the selected member ports based on acertain criterion or a set of criteria depending on your configuration.You can choose one of the following criteria or any combination of them for load sharing:z MAC addresses carried in packetsz IP addresses carried in packetsz Port numbers carried in packetsEthernet Link Aggregation Configuration Task ListComplete the following tasks to configure Ethernet link aggregation:Task RemarksConfiguring a Static Aggregation GroupConfiguring anAggregationGroup Configuring a Dynamic Aggregation GroupSelect either taskConfiguring the Description of an Aggregate Interface OptionalEnabling Link State Trapping for an AggregateInterface OptionalConfiguring anAggregateInterfaceShutting Down an Aggregate Interface OptionalConfiguringLoad Sharing forLink AggregationGroupsConfiguring Load Sharing Criteria for LinkAggregation Groups OptionalConfiguring an Aggregation GroupConfiguration GuidelinesLink aggregation cannot be used along with some features. Table 1-5 lists the ports that cannot beassigned to a Layer 2 aggregation group.Table 1-5 Ports that cannot be assigned to a Layer 2 aggregation groupPort type ReferenceRRPP-enabled ports RRPP Configuration in the High Availability Volume
