11213MENU SCREEN OPERATION12345678910111213141516171819DD GPS-A symbolSelects the desired GPS-A symbol.Available symbols: Ambulance, Bus, Fire Truck, Bicycle,Yacht, Helicopter, Small Aircraft, Ship(Power Boat), Car (default) , Motorcycle,Balloon, Jeep, Recreational Vehicle,Truck, Van, OtherIf “Other” is selected, set the desired symbol code as follows;q Push [MAIN•BAND] to enter programming condition.w Rotate [DIAL] to select the 1st character from “\” and “/.”e Push [>](M/CALL•MW) (Left band’s) to select the 2nd digit.r Rotate [DIAL] to select the 2nd digit character.t Push [MAIN•BAND] to program the symbol code.When “Other” is selected, check the symbol codes ofAPRS, ® and set it correctly.DD CommentProgram up to a 43-character* comment. The programmedcomment is transmitted with the GPS position data.*36-character comment can only be programmed when“COURSE/SPEED” is selected in data extension.q Push [MAIN•BAND] twice to enter programming condition.wRotate [DIAL] to select the desired character.• Push [Aa](TONE•DTMF) to select the character group from cap-ital letters or lower case letters.• Push [1/](M/CALL•MW) (Right band’s) to select the charactergroup from numbers or symbols.• Push [>](M/CALL•MW) (Left band’s) or [<](V/MHz•SCAN) (Leftband’s) to move the cursor right or left, respectively.• Push [CLR](DUP/MONI) to clear the selected character.• Push and hold [CLR](DUP/MONI) for 1 sec. to clear all charac-ters after the selected character.eRepeat steps w until the desired comment is programmed.r Push [MAIN•BAND] to set the programmed comment.tPush [BACK](V/MHz•SCAN) (Right band’s) to return to theGPS-A set mode screen.
