666MEMORY MODE OPERATION12345678910111213141516171819[EXAMPLE]: Programming the bank name “AIR” into the scan edge channel 3A.Enter “I” and “R” with (Mainband’s) and (Left band’s), thenpush (Right band’s) to selectmemory write mode.V/MHzSCANM/CALLMWPush and hold (Left band’s) for 1 sec. to program.M/CALLMWPush (Main band’s) to select memory mode.Rotate (Main band’s) toselect “A”, then push .M/CALLMWPush and hold (Main band’s) for 1 sec.to enter select memory write condition.Push (Main band’s) several timesto select “B NAME”.Push (Right band’s) to enter bankname edit mode.*Select “M NAME” or “S NAME” when programing the memory name or thescan name, respectively.Bank name edit modeSelect memory write modeMemory mode SELEDITM/CALLMW>Rotate (Main band’s) to select scan edgechannel 3A.MAINBANDMAINBANDMAINBANDM/CALLMW>V/MHzSCANBACKM/CALLMWS.MWDD To indicate the channel nameThe channel name indication can be set independently foreach memory channel.q Select the desired memory channel in the main band.➥ Push the same band’s [M/CALL•MW] several times toselect memory mode, then rotate the same band’s [DIAL]to select the desired memory channel.• “X” and memory channel number appear.w Push [F• ] to display the function guide.ePush [M.N](LOW•PRIO) several times to select “MEMORYNAME,” “FREQUENCY” or OFF.• When “MEMORY NAME” is selected, the programmed memoryname is indicated above frequency indication; when “FRE-QUENCY” is selected, the programmed memory name is indi-cated at the frequency indication and the programmed frequencyis indicated above the memory name.r Push [F• ] twice to exit the function guide indication.NOTE: When no memory name is programmed, the storedfrequency is displayed.
