525DV MODE OPERATION (Optional UT-123 is required)12345678910111213141516171819■ Message operationDD TX message programmingTX messages are available for up to 5 channels, and eachchannel can be programmed with a message of up to 20characters. Available characters are 0 to 9, A to Z (capital let-ters) , a to z (lower case letters) , some symbols and space.q Push [F• ] to display the function guide.wPush [MENU](V/MHz•SCAN) (Right band’s) to display the“MENU” screen.eRotate [DIAL] to select “DV MESSAGE,” then push[MAIN•BAND].rRotate [DIAL] to select “TX MESSAGE MEMORY,” thenpush [MAIN•BAND].tRotate [DIAL] to select the desired message memorychannel, 01 to 05, then push [MAIN•BAND].• Previously message is displayed if programmed.yRotate [DIAL] to select the desired character.• Push [Aa](TONE•DTMF) to select the character group from cap-ital letter characters or lower case letters.• Push [1/](M/CALL•MW) (Right band’s) to select the charactergroup from numbers or symbols.• Push [>](M/CALL•MW) or [<](V/MHz•SCAN) (Left band’s) tomove the cursor right or left, respectively.• Push [CLR](DUP•MONI) to clear the selected character.u Repeat the step y to enter the desired message.• Up to 20-character messages can be set.i Push [MAIN•BAND] to store the message.ePush [BACK](V/MHz•SCAN) (Right band’s) twice to exitfrom DV message screen.
