Icom IC-V82 Instruction Manual

Also see for IC-U82: Instruction manual Addendum Specifications Service manual Instruction manual

Contents

52PANEL DESCRIPTION2[3• T.SCAN ]➥ Input digit “3” during frequency input, memorychannel selection, etc. (pgs. 13, 20)➥ After pushing [A• FUNC ], starts the tone scan-ning. (pgs. 18, 35)[4• DUP ]➥ Input digit “4” during frequency input, memorychannel selection, etc. (pgs. 13, 20)➥ After pushing [A• FUNC ], selects a duplex func-tion (–duplex, +duplex, simplex). (p. 17)[5• SCAN ]➥ Input digit “5” during frequency input, memorychannel selection, etc. (pgs. 13, 20)➥ After pushing [A•FUNC], starts scanning. (p. 28)[6• SKIP ]➥ Input digit “6” during frequency input, memorychannel selection, etc. (pgs. 13, 20)➥ After pushing [A• FUNC ], sets and cancels skipsetting for memory skip scan during memorymode. (p. 30)[7• PRIO]➥ Input digit “7” during frequency input, memorychannel selection, etc. (pgs. 13, 20)➥ After pushing [A• FUNC ], starts the prioritywatch. (p. 30)[8• SET]➥ Input digit “8” during frequency input, memorychannel selection, etc. (pgs. 13, 20)➥ After pushing [A• FUNC ], enters into SET MODE .(p. 57)[9• H/M/L]➥ Input digit “9” during frequency input, memorychannel selection, etc. (pgs. 13, 20)➥ After pushing [A• FUNC ], switches transmitpower from high, middle and low output power.(p. 15)[0• OPT]➥ Input digit “0” during frequency input, memorychannel selection, etc. (pgs. 13, 20)➥ After pushing [A• FUNC ], selects an optionalfunction mode, such as pager, code squelch ordigital operation. (pgs. 38, 40)[#• BANK ]After pushing [A• FUNC ], enters a memory bankcondition. (p. 24)[✱•ENT ]➥ Sets the frequency even if the full 6-digits offrequency have not been entered. (p. 13)➥ After pushing [A•FUNC], switches key lock func-tion ON and OFF when pushed for 1 sec. Lockall keys, except [PWR], [PTT], [MONI] andaudio level adjustment. (p. 16)ENTBANKOPT0H/M/L9SET8PRIO7SKIP6SCAN5DUP4T.SCAN3