Icom IC-V82 Instruction Manual

Also see for IC-U82: Instruction manual Addendum Specifications Service manual Instruction manual

Contents

318SCAN OPERATION8D Memory scan watchWhile operating on a VFO frequency or the call channel, mem-ory scan watch monitors for signals in each memory channelin sequence, every 5 sec.q Push [C• MR ] to select memory mode, if necessary.• “X” appears.wPush [A• FUNC ], then push [5• SCAN ] to start the memoryscan.e Push [A• FUNC ], then push [7• PRIO] to start the watching.• VFO is displayed, then the decimal point “.”, on the frequencyreadout blinks.• When the signal is detected on the priority channel, the watchingis paused according to the setting of the scan resume condition.r Push [D• CLR ] to stop the watching.■ Scan resume conditionWhen a signal is received during scanning, the scan resumecondition determines what action the transceiver takes. Thetransceiver has 2 scan resume conditions available asillustrated below. Use SET MODE to select the one which bestsuits your needs.q Push [A• FUNC ], then push [8• SET] to enter SET MODE.wPush [YY] or [ZZ] several times until “SCP” or “SCt” ap-pears.e Rotate [VOL] to select the desired scan resume condition.• Pause scan:When receiving a signal, scan pauses onthe signal until it disappears. Resumes2 sec. after the signal disappears.• Timer scan:When receiving a signal, scan pauses onthe signal for 5 sec., 10 sec. or 15 sec.,then resumes.r Push [✱•ENT ] (or [D• CLR ])to set and exit SET MODE.Timer scanPause scanUSING SET MODESKIPMch 1Mch 2Mch 3Mch 4Mch 5Mch 199 Mch 6Priority channelMemoryscan5 sec.50 msec.VFO frequency