Icom IC-V82 Instruction Manual

Also see for IC-U82: Instruction manual Addendum Specifications Service manual Instruction manual

Contents

72PANEL DESCRIPTION2❍ While in the digital (DV) mode operation with the in-stalling an optional Digital unit UT-118.➥ “ ” appears while the digital code (CSQL) squelchfunction is in use. (p. 47)➥ “ ” appears while the call sign (DSQL) squelch func-tion is in use. (p. 47)➥ “ ” appears with the “ ” or “ ” indicator while thepocket beep function (CSQL or DSQL) is in use.(p. 46)y TRANSMIT INDICATOR (p. 15)Appears during transmit.u FREQUENCY READOUTShows operating frequency, channel number or channelnames, depending on display type (p. 16).i SIGNAL INDICATOR➥ Shows receiving signal strength as below.➥ Shows the output power level while transmitting.o BUSY INDICATOR➥ Appears when a signal is being received or the squelchis open.➥ Blinks while the monitor function is activated. (pgs.15,47)!0 PAGER CALL INDICATOR (p. 39)Blinks when a pager call is received. (This indicator ap-pears only when UT-108 is installed.)!1 DIGITAL MODE INDICATOR (p. 43)Appears when digital mode is selected. (This indicator ap-pears only when UT-118 is installed.)!2 LOW/MIDDLE POWER INDICATOR (p. 15)➥ “L” or “M” appears when the low or middle output poweris selected, respectively.➥ No indicator appears when high output power is se-lected.!3 SKIP CHANNEL INDICATOR (p. 30)Appears when the selected memory channel is specifiedas a skip channel.!4 MEMORY MODE INDICATOR (p. 20)Appears while in memory mode or channel number indica-tion mode.!5 MEMORY CHANNEL INDICATOR (p. 20)➥ Shows the selected memory channel number.➥ “C” appears when the call channel is selected.Low Middle HighWeak ⇐ RX Signal level ⇒ Strong