Kenwood TH-22A Instruction Manual

Also see for TH-22A: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

BATTERY INFORMATIONNiCd BATTERY PACK (PB-32/PB-34) Note:You must charge the battery pack before you can use it paliabarging: shculc:be dove within an ambien.charg ry Pp ay : temperature between 5°C to 40°C (41°F to 104°F).The pack is delivered uncharged to provide you with the Recharging outside this range may not fully charge thegreatest number of charge/discharge cycles. It takes battery.several charge/discharge cycles before achieving the full > ff the entire display is blinking, or if turning PWR/VOLbattery pack capacity. After storing the pack for more Coes Ns nat power the transceiver, recharge theattery pack.than 2 months, recharge it before use.» The BC-17 charger is designed to recharge only PB-32,PB-34, PB-30 (option), or PB-33 (option). Never use: the BC-17 to recharge other types of batteries.mg RechargingInsert the plug from the BC-17 charger into the DC IN a Installing/Removing the Battery Packjack on the right side of the transceiver. Then plug Insert the battery pack into the bottom of thethe charger AC plug into an AC wail outlet. Do not transceiver, and push in until the tab on the packcharge the battery for more than 15 hours. Exceeding locks in place.the recommended charge period shortens the usefullife of the pack and adversely affects batteryperformance.; To remove the battery pack, simultaneously press theDC IN jack tab on the back of the pack while pulling out the packfrom the transceiver.