Keysight Technologies E4360 Series User Manual

Also see for E4360 Series: Service guide Service guide

Contents

4 Using the Solar Array Simulator84 Series E4360 User’s GuideFront Panel: SCPI Command:Log into the Admin menu as previouslydescribed. Then select USB.Check Enable USB to enable the USBinterface. Un-check this box to disablethe USB.Not Available.Restoring the Non-volatile Factory SettingsRemote interface and certain front panel control settings are stored innon-volatile memory (refer to the following table). Changes to any non-volatile settings will be remembered and applied the next time theinstrument is turned on.To restore all nonvolatile settings to their factory defaults:Front Panel: SCPI Command:Log into the Admin menu as previouslydescribed. Then select Nvram.Press Reset to restore the factory-shippednon-volatile settings.Not Available.The factory-shipped non-volatile LAN interface settings documented inthe following table are optimized for connecting your SAS to a sitenetwork. They should also work well for other network configurations. Torestore only the non-volatile LAN settings to their factory defaults, selectthe System\IO\LAN\Config\Reset menu.Factory-shipped non-volatile LAN settingsDHCP Enabled Host name A-E4360-xxxxxAutoIP Enabled Use DNS naming service EnabledIP Address 169.254.67.0 Use NetBIOS naming service EnabledSubnet Mask 255.255.0.0 Domain name BlankDefault Gateway 0.0.0.0 TCP keepalive EnabledObtain DNS server from DHCP Enabled TCP keepalive seconds 1800DNS server BlankOther factory-shipped non-volatile settingsAdmin/Calibration password 0 (zero) On/Off key affects allchannelsDisabledCalibration date March 5, 2008 Output Inhibit mode OffChannel grouping No groups Saved states *RST commandDigital port function (all pins) Digital In Screen contrast 50%Digital port polarity (all pins) Positive Screen saver EnabledFront panel lockout Disabled Screen saver delay 60 minutesFront panel meter view 1-channel USB interface EnabledGPIB Address 5 Wake on I/O EnabledKey clicks Enabled Web server EnabledLAN interface Enabled