4-50 Configuring Your ServerCreate RAID via allows you to select between the different creation methods for RAID0and RAID1. The following table gives examples of when each is appropriate.RAID level Create RAIDviaHow to createRAID0 No Init Creates a RAID0 on new drives.RAID0 Migrate Adds a new drive to the existing drive that contains data(migration). The server does not support [Migrate] feature.RAID1 Build* Copy the data in the existing drive and creates RAID1drive.RAID Clear Clears all the data in the drive and creates new RAID1drive.RAID1 Quick Init Fastest way to create a RAID1 drive.* When you start creating RAID, a window to select the copy source drive (existing drive)appears. The data in the selected drive is copied to the new drive to configure RAID. Notethat the data in the destination drive is erased.IMPORTANT: The server does not support Migrate option.NOTES: Before adding a new drive to an existing array, back up any datacontained on the new drive. Otherwise, all data will be lost. If you stop the Build process on a RAID1 from ACU, you can onlyrestart it from Adaptec Storage Manager - Browser Edition orAdaptec Storage Manager. A RAID1 created using the Quick Init option may return some datamiscompares if you later run a consistency check. This is normaland is not a cause for concern. The ACU allows you to use drives of different sizes in a RAID1.During a build operation however, only the smaller drive can beselected as the copy source or first drive. We do not recommend that you build an array on Windows dynamicdisks (volumes), as it will result in data loss.10. Select a source drive from the [Select Source Drive] list box and press Enter.
