8-26 TroubleshootingProblems with Configuration Diskette CreatorThe bit map of the Configuration Diskette Creator window is not displayed correctlyduring setting of setup information. (When the Trekking command is used)→ If the specified number of colors is fewer than 256 in the display setting, the bit mapis not displayed correctly, but the setup information can be displayed correctly.The Point to Point tunneling protocol cannot be set.→ The protocol is not supported at present. After installation, set the protocol throughControl Panel. In this case, rebooting is not necessary.The details of a network adapter cannot be set.→ Configuration Diskette Creator is unable to set the details of network adapters. StartWindows 2000/Windows Server 2003, and set the details through Control Panel.More than one network board is connected during setting of setup information, butTCP/IP cannot be set for each network.→ Perform the installation procedure during DHCP setting. To create a temporary IPconfiguration, perform the installation procedure during DHCP setting, and then setTCP/IP again through Control Panel.Problem with Disk ArrayRefer to the manual that comes with the disk array controller for any trouble occurred on disk arrayin this system.
