E-10 Installing Windows Server 20037. When the following message is displayed, press S.Setup could not determine the type of one or more mass storage devicesinstalled in your system, or you have chosen to manually specify an adapter.Currently, Setup will load support for the following mass storage devices.The following message is displayed.Please insert the disk labeledmanufacturer-supplied hardware support diskinto Drive A:*Press ENTER when ready.8. Insert the Windows Server 2003 OEM-DISK for NEC EXPRESSBUILDER into thefloppy disk drive, and press Enter. A list of SCSI adapters will be displayed.SATA Model: A list of mass storage devices is displayed.SCSI Model: Select the [Adaptec Ultra320 SCSI Cards (WinXP/Server 2003 IA-32)] andpress Enter.9. If the optional board is installed, select the proper SCSI Adapter and press Enter.– Adaptec Ultra160 SCSI Cards (Win Server 2003)(When N8103-56 board is installed.)– Adaptec Ultra320 SCSI Cards (WinXP/Server 2003 IA-32)(When N8103-75 board is installed.)– Adaptec I2O RAID Driver Disk for 32bit Windows 2000/XP/2003(When N8103-86 board is installed.)– Adaptec HostRAID U320 Driver Ver 1.02 For Windows 2000/XP/2003(When Adaptec HostRAID (SCSI) is installed.)– Adaptec Embedded Serial ATA HostRAID Driver For Windows 2000/XP/2003(When Adaptec HostRAID (SATA) is installed.)– MegaRAID SCSI 320-1 RAID Controller Driver (When N8103-80F board is installed.)– MegaRAID SCSI 320-2 RAID Controller Driver (When N8103-81F board is installed.)Continue performing tasks according to the subsequent messages that appear.10. When the following message is shown, press Enter to start "Welcome to Setup".11. When the installation of Windows Server 2003 has finished, the system rebootsautomatically.– Windows Server 2003 has been installed: Go on the step 15.– Windows Server 2003 R2 has been installed: Go on the step 12.
