5-10 Installing the Operating System with Express Setup7. If you select "Yes" at step 5, place a floppy disk into the floppy disk drive mounted on theserver.If not, go on the next step.NOTE: If you set the floppy disk at this step, do not remove thefloppy disk from the server until the message as removing the floppydisk appears.[Using the existing Configuration Disk]The parameters files in the floppy disk is listed in dialog-box.1) Select a parameters file to use in the Express Setup.After the parameters file is specified, the message "Do you want to review or modifythe Setup File parameters?" appears.2) If you want to modify or confirm the parameters file, click [Review]. If not, click[Skip].Click [Review] → Go on the next step.Click [Skip] → Go on the step 9.NOTE: If you do not use disk array controller, go on the step 9. Afterthat, the dialog-box appears.[Using a blank disk]1) Click the box under [Setup File Name: (A)] or press A.The dialog box appears.2) Input the file name and click [Use].8. Confirm or modify the parameters of disk array configuration.NOTE: If you do not use disk array controller, go on the next step.If a Disk array controller is connected to the server or the HostRAID is enabled, the[Configure RAID] dialog-box appears. Confirm the parameters, modify if necessary, andthen click [OK].When the dialog-box is closed, the Express setup automatically performs the RAIDconfiguration, creating Maintenance partition and installing several utilities.9. Select the installing Operating system.Select "Windows" from the menu.
