General Description 2-5Front View with Front Bezel Removed1 Handles (1 at the right and left each)Hold the handles when dismounting/mounting the server from/in the rack.2 Serial port B (COM B) connectorConnect device having a serial interface to this connector (such as remote console PC).3 USB connectors (2 ports)Connect device compliant with the USB interface to the connectors.4 DUMP (NMI) switchPress this switch to dump system memory.5 POWER switchPress this switch to turn on/off the power. Pressing the switch once turns on the power, andthe POWER LED goes on. Pressing it again turns off the power. Keep pressing the switchfor 4 seconds or more forcibly turns off the power.6 UID (Unit ID) switchPress this switch to turn on/off the UID LEDs on the front and rear panels of the server.Pressing the switch once turns on the LEDs. Pressing it again turns them off.7 Optical disk drive (CD-ROM drive)This drive reads data from the CD-ROM.7-1 Disk access LED 7-2 CD tray eject button 7-3 Emergency hole8 3.5-inch floppy disk driveThis drive reads/writes data from/to the 3.5-inch floppy disk.8-1 Disk access LED 8-2 Disk slot 8-3 Eject button9 Hard disk drive baysMount SCSI hard disk drives in the bays. Each number following the bold-faced numberindicates the SCSI ID. In the standard configuration, the hard disk drive trays are mounted inall the bays.10 DISK LED (green/amber)Hard disk drive LED. Each hard disk drive LED is green during access to the hard disk drive.The LED turns amber when the hard disk drive fails. The LED flashes switching back andforth between green and amber during build processing (in only disk array configuration).11 SATA hard disk drive baysMount SATA hard disk drives in the bay. The left side bay is connected to channel 1 of theSATA connector on the mother board. The right side bay is connected to channel 2 of theSATA connector on the mother board.See 3 - 7 on the previous page.Hot-plug SCSI hard disk drive model9-19-0SATA fixed hard disk drive model1 2 3 4 5 6 7-1 7-2 7-3 8-1 8-2 8-3 19-29-0 10 9-1
