Upgrading Your Server 9-35InstallationTake the following steps to install a PCI board on the riser card:IMPORTANT: The full-height riser card is equipped with an"insulator (black)" to protect PCI boards. Do not remove the insulator,and handle it carefully. The insulator is not shown in the figures inthis manual for simplifying the illustrations.NOTES: Each riser card supports low-profile or full-height PCI boards.Before installing a PCI board, confirm that the type of the PCIboard. When installing a PCI board, confirm that the card connectormatches the connector of the riser card.1. See the section "Preparing for Installation and Removal" described earlier to prepare.2. Pull out the server from the rack.3. Remove the drive cover and logic cover.4. Grasp a handle on the riser card assembly and lift straight up and remove the riser cardfrom the server.5. Remove the screw from the riser card, and remove the extension slot cover.NOTE: Keep the removed extension slot cover for future use.Low-Profile side Full-height sideExtension slot coverExtension slot cover
