Upgrading Your Server 9-576. Push the 5.25-inch device to the device bay carefully.NOTE: Make sure that the cables are not caught while the 5.25-inchdevice is pushed into the slot.IMPORTANT: If a 5.25-inch device occupying two slots cannot beinserted easily, push the device to the slots with it lifted a little.7. Fix the rails by using the screws removed in step 3.Single-height device Double-height device8. Check whether the installed 5.25-inch device is projected too much from the front of theserver.Check the device installed in a 5.25-inch device bay based on the factory-installed opticaldisk drive.9. Connect the interface and power cables to the 5.25-inch device installed from the left sideof the server.See Chapter 10 for cable connection.IMPORTANT: Connector pin bending or incomplete connection maycause a malfunction to occur. Provide the connection securely watchingthe 5.25-inch device and cable connectors.NOTE: Make sure that the cable is not caught.10. Install the removed components.11. Setup the SCSI BIOS for the SCSI device according to the manual that comes with theSCSI controller.12. Install the device driver according to the manual that comes with the device.
