4-2 Configuring Your ServerStarting SETUP UtilityPowering on the server starts POST (Power On Self-Test) and displays its check results. If the NEClogo is displayed, press Esc.After a few seconds, the following message appears at bottom left on the screen.Press to enter SETUP or Press to boot from NetworkPress F2 to start the SETUP utility and display its Main menu.If you have previously set a password with the SETUP utility, the password entry screen appears.Enter the password.Enter password:[ ]Up to three password entries will be accepted. If you fail to enter the password correctly for threeconsecutive times, the server halts. (You can no longer proceed.) Power off the server.NOTE: The server is provided with two levels of password:Supervisor and User. With the Supervisor password, you can view andchange all system parameters. With the User password, systemparameters available for viewing and changing are limited.
