Configuring Your Server 4-5MainOption Parameter Description Your SettingSystem Time HH:MM:SS Set the system time.System Date MM/DD/YYYY Set the system date.Hard Disk Pre-Delay [Disabled]3 seconds6 seconds9 seconds12 seconds15 seconds21 seconds30 secondsWhen accessing the internal IDEdevice for the first time duringPOST, the system waits for thespecified time until the devicebecomes ready.Primary IDE Master/Primary IDE SlaveSecondary IDE Master/Secondary IDE SlaveSelect submenu Set the information on the deviceconnected to each channel onthe submenu. The settings ofsome items may be changed.However, leave the items as theyare at the shipment.Processor Settings Select submenu Shows the processor settingssubmenu.Language [English (US)]Français (FR)Deutsch (DE)Español (SP)Italiano (IT)Select which language BIOSdisplays.[ ]: Factory-setIMPORTANT: Check and adjust the system clock before theoperation if any of the following conditions is applicable.– After carriage of device– After storage of device– After the device is entered into the pause state under theenvironmental condition enduring device operation (temperature:10°C - 35°C, humidity: 20% - 80%)Check the system clock at the rough rate of once per month. When thesystem clock is installed in a system requiring high time precision, it isrecommended to use a time server (NTP server).If the system clock is remarkably delayed or advanced as the passage oftime in spite of adjustment, contact your service representative to askmaintenance.
