10-4 Internal Cabling DiagramsInstalling Internal SCSI File DeviceTo install the internal SCSI file device, you need prepare a separately priced SCSI controller andSCSI cable.IMPORTANT: Up to two SCSI devices can be installed in the server. To install two half-height SCSI devices in the 5.25-inch device bay,move the factory-installed optical disk drive to the top bay.SCSI controller: N8103-75F, N8103-95SCSI cable: K410-68 internal SCSI cableK410-68 internal SCSI cable is equipped with terminating resistor. Set "Disabled" for all theterminating resistors of connected devices. For other setting, refer to the manual provided with thedevice.A file device needs settings such as a SCSI transfer rate. For the transfer rate, see the manualprovided with the file device. Use the BIOS utility of the SCSI controller to make the settings. Fordetails, see the manual provided with the SCSI controller.Mother boardPCIe #5PCIe #4PCIe #3PCI #2PCI-X #1SAS cable SCSI cableIDE cableSCSI controller(SCSI device)(IDE device)Optical disk drive5.25-inchdevice bay3.5-inch harddisk drive bayHard disk drivesare optional.PCIe #6IDEID3ID2ID1ID0Internal RAIDcontrollerTerminatorK410-68 internal SCSI cable
