Using the Océ 9600 Printer 333 Press the right selection button to activate the Mat. (Material) option.The dotted line around the current selection is changed into an uninterruptedline and the small selection triangles next to the specified material are nolonger dimmed.4 Use the Up/Down buttons to select the material you just loaded.5 Press the on line button to put the printer on line again. The printer now knowswhich material is used for the specified roll or cassette tray. Set media type for manual feeder1 Press the on line button on the printer operating panel to put the printer off line.The ‘Off line’ message is displayed in the status window.2 Press the left selection button to shift the focus to the Media option.A shadow effect is used to indicate that the focus is set to this option.3 Use the Up/Down buttons to select the Manual option.4 Press the right selection button to activate the Mat. (Material) option.The dotted line around the current selection is changed into an uninterruptedline and the small selection triangles next to the specified material are nolonger dimmed.5 Use the up/down buttons to select the material you just loaded.6 Press the on line button to put the printer on line again. The printer now knowswhich material is used by the manual feeder. Set media size1 Press the on line button on the printer operating panel to put the printer off line.The ‘Off line’ message is displayed in the status window (see figure 10 onpage 32).2 Press the left selection button to shift the focus to the Media option.A shadow effect is used to indicate that the focus is set to this option.3 Use the up/down buttons to select the roll or cassette tray for which you havejust loaded new media.4 Press the right selection button to activate the Size option.The dotted line around the current selection is changed into an uninterruptedline and the small selection triangles next to the specified size are no longerdimmed.5 Use the up/down buttons to select the size of the media you just loaded.6 Press the on line button to put the printer on line again. The printer now knowswhich media size is used for the specified roll or cassette tray.
