Using the Océ 9600 Copier 51Specifying the zoom factorYou can use the ‘Zoom’ setting to select a zoom factor. If you select‘Automatic’ with the ‘’ symbol, the Océ 9600 Copier will use a zoom factorthat is needed to obtain a copy without loss of information. This will be doneaccording to the selected media roll or cassette tray. After inserting theoriginal, the zoom factor that is used is indicated by the ‘❍’ symbol.If you select the numeric zoom factor with the ‘’ symbol, you can define azoom factor yourself between 25% and 400%. After selecting the numericzoom factor, the four little triangles will appear to the right. Now you candefine a new zoom factor in two different ways: By using the Arrow buttons on the right of the display (see figure 12 onpage 40). If you press one of the vertical buttons, the zoom factor willincrease or decrease with steps of 0.1%. If you press one of the horizontalbuttons, the zoom factor will increase or decrease with the steps predefinedin the Settings Editor by the key operator. By using the numeric buttons at the bottom of the operating panel. You canspecify the exact zoom factor in increments of 0.1%.For example, if you want to specify a zoom factor of 25.4%, you type 254. Ifyou want to specify a zoom factor of 254%, you type 2540. Selecting the zoom factor1 Select the ‘Image’ card in the ‘Copy’ section.2 Select the desired media with the ‘Zoom’ function button.[19] Selecting the zoom factorNote: You can also select the zoom factor from the ‘Custom’ section (if thissetting has been defined for this).Access toialAccess toPageInterruptjob
