54 Océ 9600 Copier/Printer User ManualUsing the manual feeder for copyingIf you want to copy a job on a media type and/or size that is not available onone of the paper rolls or cassette trays, it is more convenient to manually feedsheets instead of switching paper rolls or cassette trays. The sheet feed is aspecial slot just above the roll drawers on the engine. You can insert pre-cutcopy material in this slot, one sheet at a time.Note: Only use media as specified in ‘’ on page 287. Copying on pre-cut sheets1 Open the ‘Sheet’ card in the ‘Copy’ section.2 Press the ‘Manual feed’ button. The display will look as follows:[22] Using the manual feed option3 Select any other required settings.4 Enter the number of copies using the numeric buttons.5 Feed in the original.6 Press the start button.7 Take your sheet of copy material to the side of the printer engine that containsthe sheet feed.8 Use both hands to align the copy material in accordance with the formatindication and the sticker on the manual feed table.9 Move the copy material forward onto the tip of the roller. This should cause anample paper bulge over the full width of the page.10 Hold the paper with both hands until the engine pulls in the first part of thesheet.The bulge will be reduced or disappear. A few seconds later, the complete sheetwill be pulled into the printer.Note: If the copy job requires more sheets, the display will ask you to feedin the next sheet.11 Repeat steps 7 to 11 to complete the job.12 Collect your output.
