- 167 -Troubleshooting1010.TroubleshootingThis chapter explains items on the limits of initializing, deleting and updating drivers, and when in sleepmode. InitializingThis section explains how to initialize an SD memory card and flash memory, and how to reset theequipment settings to their defaults.You can delete data or settings stored on the machine to restore the settings at the time of purchase.Note In the default settings, [Initialize] cannot be selected because [Initial Lock] is set to [Enable]. [Set [Initial Lock] to[Disable] in [Storage Maintenance Setup]. For details on the initial lock, refer to "Management" P. 97.Memo [In order to access the [Admin Setup] menu, an administrator password is required. The default password is "aaaaaa".Initializing an SD memory card(for MB491/ES4191 MFP Only)Carry out initialization of an SD card wheninserting a card that has either been used inother equipment or when it has not beenproperly recognized.An SD memory card is used as a storage forspooling when copying sectors, saving secureprint/ encrypted print data, form data andmacros. Initialization deletes stored data.An SD memory card has three partitions. Theyare PS, Common, and PCL. When initialized, it isdivided into partitions again. You can also formatparticular partitions individually.Formatting the Entire AreaYou can format the entire area of the SD memorycard installed in the machine.Note When you initialize all areas of an SD memory card, thefollowing data is deleted:- [Stored job data subject to [Secure Print], [EncryptedSecure Print] or [Store to SD Card].- Custom demo data- Font data1 Press the <SETTING> key2 Press to select [Admin Setup] andthen press .3 Enter the administrator password.4 Select [Enter], and then press .5 Press to select [Management] andthen press .6 Press to select [SD Memory CardSetup] and then press .7 Check that [Initialize] is selected andthen press .8 Check that [Execute] is selected andthen press .A message appears confirming you thatcontinuing will automatically restart the system.Select [Yes] to continue.Formatting a particular partitionYou can initialize a particular partition within theSD memory card's 3 partitions (PS, Common,and PCL).Note When you initialize a partition, the following data isdeleted:- PS: Font data in PS area- Common: Job data and demo data stored with [SecurePrint], [Encrypted Secure Print] or [Store to SDCard].- PCL: Font data in the PCL area1 Press the <SETTING> key.2 Press to select [Admin Setup] andthen press .3 Enter the administrator password.4 Select [Enter], and then press .OKOKOKOKOKOKOKOK
