Various Functions for Transmission- 18 - Various Functions for TransmissionThis section explains various functions for fax transmission.Memo To enter the [Admin Setup] menu, the administrator password is necessary. The default password is "aaaaaa".Reference For details on how to specify a destination, refer to the User's Manual Basic.RedialingAutomatic RedialingThe machine automatically redials if the first faxtransmission fails. Redial is automatically donewhen the recipient machine is busy or does notanswer, or when a communication error happens.To set the number of redial attempts and theirinterval, perform the following procedures.Memo When the transmission failed though the machine triedredials for the specified times, the document stored inmemory is erased and an error message is printed out.1 Press the <SETTING> key.2 Press the to select [Admin Setup]and then press .3 Enter the administrator password.4 Select [Enter] and then press .5 Press the to select [Fax Setup] andthen press .6 Press the to select [Other Settings]and then press .7 Check that [Redial Tries] is selectedand then press .8 Press to specify the desired number ofredial attempts and then press .9 Press the to select [Redial Interval]and then press .10 Specify the desired redial interval usingthe ten-key pad and then press .11 Press the until the top screen appears.Manual RedialingTo redial manually, specify the desireddestination from the transmission history.Destination can be also selected by pressing theREDIAL key.Reference For details on the transmission history, refer to the User'sManual Basic.Transmission in Real TimeThe scanned fax data is stored in memory beforethe machine starts transmission. This is calledmemory transmission. The fax data istransmitted while it is scanned. This is called realtime transmission. Real time transmissionThe real time transmission is a method totransmit data to a destination party withoutstoring document data in memory. In this mode,transmission starts right after the transmissionoperation, and this allows you to check that thefax is transmitted to its destination. Memory transmissionThe memory transmission is a method totransmit after storing document data in memory.In this mode, you do not have to wait for themachine to finish transmission.The factory default is set to the memorytransmission.To enable the real time transmission, perform thefollowing operation.Note You can scan only a single page when using the documentglass for real time transmission. While you send a fax by using real time transmission, otherjobs using the ADF and document glass cannot be done.1 Press the <FAX/HOOK> key.2 Check that [Fax] is selected and pressto open the fax start screen.OKOKOKOKOKOKOKOKOK
