Panasonic AG-DTL1 Operating Instructions Manual

Also see for AG-DTL1: Operating instructions

Contents

62RS-232CO Query control commandsData transmitted by PC Data returned from unit in response Description of command[STX] QLH [ETX] [STX] LHRhhhh [ETX] Queries the current value of the hour meter.[STX] QLM [ETX] [STX] LRMm [ETX] Queries the timer recording mode setting.[STX] QLP:n [ETX] [STX] LPLnn:data1:data2 [ETX] Queries the POWER LOSS MEMORY data.[STX] QLT [ETX] [STX] LTMm [ETX] Queries the setting of the recording/playback time mode.[STX] QMA [ETX] [STX] LMAm [ETX] Queries the search mode.[STX] QMP [ETX] [STX] LMPp:c0c1c2c3 [ETX] Queries the settings for switching the screen display (4-in-1or 1-screen display) and for the camera numbers.[STX] QNL [ETX] [STX] LLLm [ETX] Queries the synchronization system setting for the camerasto be connected.[STX] QNR [ETX] [STX] VNRm [ETX]Queries the setting of the video signals which are to beoutput to the monitor screen in all modes except for therecording mode.[STX] QLZ [ETX] [STX] LBZm [ETX] Queries the setting of the buzzer operation during alarmrecording or sensor recording.[STX] QIP:n [ETX] [STX] LIPn:data1:data2:t [ETX] Queries the internal timer recording setting.[STX] QIR [ETX] [STX] LUImdata [ETX] Queries the user ID of the playback tape.[STX] QIW [ETX] [STX] LIWabcdefgh:ijklmnop [ETX] Queries the settings of the weekly timer and daily timer.[STX] QLA:m [ETX] [STX] LAmn [ETX]Queries the setting for the operation mode that is to beestablished when an alarm signal has been input at thetape-end position and for the duration of the alarmrecording and/or sensor recording.[STX] QMS [ETX] [STX] LMSm [ETX]Queries the setting of the timing at which the video signalswhich are supplied from the camera and which are to beoutput from the rear panel VIDEO OUT connector are to beswitched.[STX] QLD:n [ETX] [STX] LANnn:data1:data2 [ETX] Queries the ALARM RECALL data.[STX] QLE [ETX] [STX] LRIm [ETX]Queries the setting for alarm recording or sensor recordingif an alarm signal has been input while repeat recording isunderway or while the tape is being rewound.[STX] QOP [ETX] [STX] data [ETX] Queries the unit’s operation mode.[STX] QOR [ETX] [STX] ORm [ETX] Queries the results yielded by performing REC REVIEW.[STX] QOS [ETX] [STX] OPSdata [ETX] Queries the operation modes.[STX] QPB:m [ETX] [STX] LPBm:r:data [ETX] Queries playback tape information.[STX] QRA [ETX] [STX] RAm [ETX] Queries the ACK (acknowledge) code response setting.[STX] QRE [ETX] [STX] LRBm [ETX]Queries the setting of the buzzer operation in the event thatthe unit is kept in the stop mode for a prolonged period oftime.[STX] QRF [ETX] [STX] LNRf:p:t [ETX] Queries the settings of the recording mode, picture qualityand recording type.