Panasonic AG-DTL1 Operating Instructions Manual

Also see for AG-DTL1: Operating instructions

Contents

70RS-232C$ Search control commandsData transmitted by PC Data returned from unit in response Description of command[STX] SAS:data [ETX]Parameterdata = nn:dnn = 0—9: Alarm numberd = F: Forward directionN: Reverse direction[STX] SAS [ETX] Searches the alarm number designated by the parameter inthe direction designated by the parameter.The unit is set to STILL mode upon completion of thesearch.If the designated position is an illegal position (that is, thetarget position does not exist), error code ERT is returnedfrom the unit, and the STOP mode is established.If the OSP (STOP) command or OEJ (tape EJECT)command is assigned during operation, error code ERI isreturned from the unit.If the unit’s operation mode has been changed by anoperation at its front panel, error code ERF is returned fromthe unit.If the tape reaches its start or end during operation, errorcode ERP is returned from the unit.When data differing from the reference data has been sent,error code ERE is returned from the unit.This command is not acknowledged while a search controlcommand is being processed or while one of the followingmodes is established.EJECT, REC, REC PAUSE, REC CHECK, POWER OFF[STX] SCP:data [ETX]Parameterdata = ghmmssff(CTL data referenced)g = Blank : With a positive (+)value– sign : With a negative (–)valueh = 0—9: Hoursmm = 00—59: Minutesss = 00—59: Secondsff = 00 (fixed): Frames[STX] SCP [ETX] Searches the counter value designated by the parameter.Playback is started upon completion of the search.If the designated position is an illegal position (that is, thetarget position does not exist), error code ERT is returnedfrom the unit, and the STOP mode is established.If the OSP (STOP) command or OEJ (tape EJECT)command is assigned during operation, error code ERI isreturned from the unit.If the unit’s operation mode has been changed by anoperation at its front panel, error code ERF is returned fromthe unit.If the tape reaches its start or end during operation, errorcode ERP is returned from the unit.When data differing from the reference data has been sent,error code ERE is returned from the unit.This command is not acknowledged while a search controlcommand is being processed or while one of the followingmodes is established.EJECT, REC, REC PAUSE, REC CHECK, POWER OFF