Panasonic AJ-D810A Operating Instructions Manual

Also see for AJ-D810A: Service manual

Contents

– 102 –Recording Simultaneously with the Internal VTR and an ExternalVTRConnectionsMount the AJ-YA900P 26-pin/12-pin output adaptor (option) to the unit, connect the external VTRwith the 26-pin cable, and set the audio input level selector switch of the external VTR to“p60 dB”.SW201 on the CAM ENC Printed Circuit Board of the unit must be set to ON side.(See page 104.)Checking the Function SettingsCheck that the function to control the 26-pin interface has been set to “BOTH” or “ON” on the “VTRFUNCTION” SUB menu page of the MAIN menu screen 2 of 4. See “Selecting Functions” for adescription of the various function settings.Starting Recording1 Operate the external VTR and set it to recording paused status.2 Press the VTR START button of the unit or the VTR button of the lens. The internal andexternal VTRs start recording simultaneously. Pressing the button again sets both VTRs tothe recording paused status.If One VTR Comes to the End of its Tape During RecordingEven if one VTR comes to the end of its tape and stops, the other VTR continues recording oper-ation.Returning the VTRs to simultaneous recording status¡If the internal VTR came to the end of its tape, replace the cassette and press the VTR STARTbutton of the unit or the VTR button of the lens. The external VTR continues recording operationduring this time.¡If the external VTR came to the end of its tape, replace the cassette and operate the externalVTR to restart recording. The internal VTR continues recording operation during this time.|Note{Care should be taken as the internal VTR will assume recording paused status if the VTR STARTbutton of the unit or the VTR button of the lens is pressed after replacing the external VTR’scassette.To the 26-pin connector of theAJ-YA900P (See page 104 for mounting the26-pin/12-pin output adaptor)Audio input level selector switch: p60 dBPortable VTR(Set the audio input levelselector switch to p60 dB.)