Panasonic AJ-D810A Operating Instructions Manual

Also see for AJ-D810A: Service manual

Contents

– 70 –Adjusting the White Balance/Black BalanceAdjusting the White BalanceAdjusting the white balance and black balance in the order of AWB (white balanceadjustment)>ABB (black balance adjustment)>AWB will provide a better picture.The black balance does not normally need to be readjusted even when the power is turned off andthen turned back on.However, the white balance must be readjusted when the lighting conditions change.If black balance and white balance adjustments are started when the display mode is set to “2” or“3”, messages informing of the adjustment course and results will appear on the viewfinderscreen. Set the display mode to “1” to not display these messages.¡See “Display Mode and Setting Change Message” (page 61) for a description of setting thedisplay mode.|Notes{¡The white balance and black balance cannot be adjusted while the setting menu appears on theviewfinder screen. Therefore, be sure to set the MENU SET/OFF switch to OFF.¡The auto black balance (ABB) must be readjusted without fail when the MASTER GAIN valuehas been changed on the “LOW SETTING”, “MID SETTING” or “HIGH SETTING” SUB menupages of MAIN menu screen 1 of 4, when the super gain setting has been selected using theSUPER GAIN button, and when the GAMMA setting (ON/OFF) on the “CAMERA SETTING”SUB menu page of MAIN menu screen 1 or 4 has been switched.¡With artificial lights, particularly with fluorescent lights and mercury-arc lamps, the strength of theR, G and B colors changes in synchronization with the power line frequency even if the bright-ness of these lights appears to be constant. Especially in areas where the power line frequencyis 50 Hz, the vertical synchronizing frequency (approx. 60 Hz) of the NTSC and the frequency(50 Hz) of the lighting tend to interact. This gives rise to flicker and to a phenomenon where thehue changes along with the passage of time, and it is it impossible to obtain the proper whitebalance.These phenomena can be reduced by setting the shutter speed to 1/100. For this reason, wher-ever the unit is used under fluorescent or mercury-arc lamps and at a frequency of 50 Hz, theshutter speed must be set to 1/100 and the white balance obtained. This shutter speed of 1/100should also be used during shooting.1 Set the switches as shown in the figure.When the positions of the GAIN and WHITE BAL switches are changed, a message informingthe operator of the new settings will appear on the setting change message display area ofthe viewfinder screen. (However, this display appears only when the display mode is set to“3”.)2 Select the FILTER knob setting in accordance with the lighting conditions.¡Refer to the description of the ¨ FILTER knob (page 15) in the Shooting and Recording/Playback Function Section for examples of the FILTER knob settings. If the FILTER knobsetting is changed, a message informing the operator of the new setting will appear on thesetting change message display area of the viewfinder screen. (However, this display ap-pears only when the display mode is set to “3”.)GAIN: Normally, set to 0 dB. When it is too dark,it is set to the appropriate gain.MENU SET/OFF: OFFWHITE BAL: A or BOUTPUT: CAMFILTER knob