Panasonic AJ-D810A Operating Instructions Manual

Also see for AJ-D810A: Service manual

Contents

– 51 –Displaying Menus on the Viewfinder ScreenChanging the setting menu configurationThe setting menu can be configured by selecting only the pages necessary for the application.Pages are selected using the MENU SELECT page of the engineer menu mode.When using the engineer menu, switch the unit to engineer mode as described below.The unit is switched to user mode by setting the MENU SET/OFF switch to “SET”.The unit is switched to engineer mode by holding down the SHIFT/ITEM and UP buttons simulta-neously and setting the MENU SET/OFF switch to SET.The user and engineer modes differ as follows.User mode: Only the selected pages the setting menu can be used. The data set on eachpage is written to the non-volatile memory, allowing it to be stored for extend-ed periods of time.Engineer mode: All pages contained in the setting menu can be used. In addition, the data setat each page is written to the non-volatile memory, allowing it to be stored forextended periods of time.If, upon completion of the adjustments and settings in the engineer mode, the menu is set to beconfigured only with the frequently used pages, the pages which are often needed can be calledpromptly.(Select the method using the user menu selection procedure described on pages 138 to 140.)|Note{The engineer menu will always open if the AQ-EC1 extension control unit (optional accessory) isconnected to the unit and the unit is operated from an external source.Transferring to the MAIN menus and SUB menusUP/DOWNbuttonSUB menu¡Press the SHIFT/ITEM button to selectthe items.¡Press the UP andDOWN buttons toselect the settings.SUB MENUMAIN MENU 1/4MAIN MENU 2/4MAIN MENU 3/4MAIN MENU 4/4PAGEbuttonPAGE buttonPAGE buttonPAGE button¡To select a page in a SUB menu, first move to the MAIN menu and then select the desired SUBmenu.¡Changes are made to the settings on the SUB menus.PAGE button