– 149 –Error CodesWhen an error occurs in the unit for some reason or other, the following error codes appear in thedisplay window.Emergency ejectIf the cassette cannot be ejected by pressing the EJECT button, use a screwdriver or similar toolto press and turn the EMERGENCY screw. This enables the cassette to be removed.1 Set the power to OFF.2 Remove the rubber cap where shown in the figure. Insert a Phillips head screwdriver into thecross-shaped part of the EMERGENCY screw (red).3 While pushing in with the screwdriver, turn the EMERGENCY screw counterclockwise untilthe tape is ejected.1 This screw needs to be rotated through about 30 turns after the first turn until the unload-ing can be started.2 This screw needs to be rotated through about 120 turns after the first turn until the tape isejected.4 Remove the cassette.5 Return the rubber cap to its original position.|Notes{1. Do not turn the EMERGENCY screw except in an emergency.2. Do not turn the screw clockwise. Stop turning the screw as soon as the tape is ejected. Other-wise, the mechanism may be damaged.3. After the tape is ejected, the cassette holder will not lock into placed even when an attempt ismade to close it. Be sure to turn the power off and turn it back on to reset the mechanism’soperation, and then close the cassette holder.4. A clicking sound will be heard when the EMERGENCY screw is turned: this sound is made bythe real drive operation and is therefore not indicative of a malfunction.Cassette holderEMERGENCY screwBA Set the power to OFF.ContentsRecording signal troubleSolenoid troubleThe servo is not locked.Condensation has occurred.Supply reel troubleTake-up reel troubleCapstan troubleCylinder troubleLoading troubleCodeNo.789ABCDEFC Push in and turn at the same time.1 This screw needs to be rotated through about 30 turns afterthe first turn until the unloading can be started.2 This screw needs to be rotated through about 120 turns afterthe first turn until the tape is ejected.