– 87 –Setup Card OperationsSetting menu contents can be stored using setup memory cards (SHL-064HSRVS, option). Thisdata can then be used to quickly recreate the appropriate setup conditions. Subject data, etc. canalso be stored on setup cards. See the Setup Card Application Instructions for a detailed de-scription.¡Optional cards include the general purpose memory card (SRAM 64KB or more) which is usedas the setup card and the ATA flash memory card (4MB or more) which is used for the PictureLink function. (However, the AJ-YAP900 Picture Link adaptor board, which is available as anoptional accessory, is required when using the ATA flash memory card.)Setup Card HandlingEjecting setup cardsLift up on the lower edge of the cover to open the cover and remove the setup card.|Note{Take care not to touch the connectors at the front of the setup card.Inserting setup cardsPosition the unit so that the panel with the logo faces you, insert the setup card into the setup cardinsertion slot and then close the cover.|Note{Check that the unit is positioned with the logo facing you and that the characters are facing thecorrect direction, and then insert the card. Be sure to insert the card in the correct direction. If thecard is difficult to insert, the card may be backwards or upside-down. In these cases, do notattempt to force in the card, but check whether the card is backwards or upside-down and thenreinsert the card.Usage and storage precautionsThe following points should be observed when using and storing setup cards.¡Avoid high temperatures and humidity.¡Do not expose setup cards to water.¡Avoid electrostatic charges.Store setup cards inserted in the unit with the cover closed.
