– 88 –Setup Card OperationsSetup Card Data OperationsOperations to store setting data on setup cards and read out stored data are performed at the“CARD READ/WRITE” SUB menu page of MAIN menu screen 2 of 4.|Note{When operating the unit with a remote controller, the CARD READ/WRITE page cannot be oper-ated from the unit.Formatting setup cards1 Set the MENU SET/OFF switch to the SET position while the SHIFT/ITEM button and UPbutton are held down together.2 Press the PAGE button to display the MAIN menu screen 3 of 4.3 Press the SHIFT/ITEM button to move the cursor to the “CARD READ/WRITE” position.4 Press the UP or DOWN button to open the CARD READ/WRITE page.5 Press the SHIFT/ITEM button repeatedly to move the cursor to the CARD CONFIG. position.6 A menu shown below appears when the UP (or DOWN) button is pressed.7 Press the UP button to format the set up card. When the setup card has been formatted, themessage shown below appears.|Note{When setup cards are formatted, the setting conditions at that time are also input simulta-neously.8 When menu operations have been completed, return the MENU SET/OFF switch to OFF.The setting menu disappears from the viewfinder screen and the displays indicating the unit’scurrent status appear at the top and bottom of the viewfinder screen.{C A R DC A R DR E A DR E A D/ W R I T EO NC F I G ? ( Y : U P . N :W R I T ER E A DDO W N )S E L E C TS E L E C T11C ON F I GU S E R D A T A|¢{C A R DC A R DR E A DR E A D/ W R I T EW R I T ER E A DS E L E C TS E L E C T11C O NO KF I GUO RF M A TS E R D A T A|¢{C A R DC A R DR E A DR E A D/ W R I T EW R I T ER E A DS E L E C TS E L E C T11C O N F I GU S E R D A T A¢|
