Start-up display20 - ENGLISHPreparationStart-up displayThe initial setting screen is displayed when the projector is turned on for the first time after purchase or whenexecuting [INITIALIZE ALL] ( page 74). Set them in accordance with circumstances.In other occasions, you can change the settings by menu operations.Notez When the projector is turned on for the first time, you may be required to adjust with the zoom ring and focusring in the front of the projector body to make the menu screen clearer.Refer to “Adjusting the image” ( page 39) for details.▶■ Initial setting (display language)Select the language to show on the screen. ( page 61)1) Press ▲▼◀▶ to select the desiredlanguage.SELECTENTER PLEASE SELECT LANGUAGE.INITIAL SETTING2) Press the button to proceedto the initial setting.▶■ Initial setting (projector setup)Select an item for each of [PROJECTION METHOD]and [HIGH ALTITUDE MODE].1) Press ▲▼ to select an item.2) Press ◀▶ to switch the setting.INITIAL SETTINGSWITCH TO HIGH ALTITUDE MODE "ON" IF OVER1400m(4593Ft).PROJECTION METHODRETURNHIGH ALTITUDE MODE OFFFRONT/DESKENTERSELECT▶z[PROJECTION METHOD] ( page 67)[FRONT/DESK] Setting on a desk, etc., in front ofthe screen[FRONT/CEILING]Mounting on a ceiling using theceiling mount bracket (optional) infront of the screen[REAR/DESK]Setting on a desk, etc., behindthe screen (using a translucentscreen)[REAR/CEILING]Mounting on a ceiling using theceiling mount bracket (optional)behind the screen (using atranslucent screen)▶z[HIGH ALTITUDE MODE] ( page 67)[OFF]Using the projector at a placelower than 1 400 m (4 593 ft)above sea level[ON]Using the projector at a highaltitude (1 400 m (4 593 ft) orhigher and lower than 2 700 m(8 858 ft) above sea level)3) Press the button to completethe initial setting.Notez If you press the button in the initialsetting (projector setup) screen, you can go back tothe initial setting (display language) screen.