|
[DISPLAY OPTION] menu64 - ENGLISHSettings[STARTUP LOGO]You can set the logo display when the power is turnedon.1) Press ▲▼ to select [STARTUP LOGO].2) Press ◀▶ to switch [STARTUP LOGO].▶z The setting will change as follows each timeyou press the button.[DEFAULTLOGO][USERLOGO] [OFF][DEFAULTLOGO] Projects the Panasonic logo.[USER LOGO] Projects the logo transferred with“Logo Transfer Software” *1 .[OFF] Disables the startup logo display.*1: “Logo Transfer Software” is included in the attached CD-ROM.Notez To create the image for [USER LOGO], “LogoTransfer Software” included in the supplied CD-ROM is required.z The startup logo will disappear in approximately 30seconds.z The startup logo is not displayed even when[USER LOGO] is selected, if the log has not beentransferred with “Logo Transfer Software”.[AUTO SETUP SETTING]You can set the auto setup function.Set it to [AUTO] normally.1) Press ▲▼ to select [AUTO SETUPSETTING].2) Press ◀▶ to switch [AUTO SETUPSETTING].▶z The setting will change as follows each timeyou press the button.[AUTO] [BUTTON][AUTO]Enables the auto setup functionwhen the projected signals areswitched to the computer signals.[BUTTON]Enables the auto setup functiononly when the button is pressed.( page 42)Notez This setting is enabled only when computer orHDMI signal is input.[SIGNAL SEARCH]When the power is turned on, this functionautomatically detects the terminal to which signals areinput and sets the function to switch.1) Press ▲▼ to select [SIGNALSEARCH].2) Press ◀▶ to switch [SIGNALSEARCH].▶z The setting will change as follows each timeyou press the button.[ON] [OFF][ON] Enables input detection.[OFF] Disables input detection.Notez If [ON] is set and you press the button on the remote control when the selectedinput is no signal, the terminal to which a signal isinput is automatically detected and switched. PreviousNext |